PRODUCTS

SPIRAL WOUND GASKETS


SPIRAL WOUND GASKETS

The Spiral Wound Gaskets are composed of a metallic continuous stripe with a special shaped profile, coupled with a continuous filing stripe (Asbestos, PTFE, Grafoil, Ceramic etc) evenly wound in concentric spiral under constant stress. The Spiral Wound Gaskets are reinforced on the inner and outer diameter by winding of several electrically welded spiral metal only. The normal shape is circular but it is possible to make oval shape, oblong shape. They can also be combined with jacketed gaskets to tightening heat exchangers internal shapes.

Spiral Gaskets are manufactured in following types:
Spiral Without Inner And Outer Ring Suitable For Groove Flanges. These are suitable for large tongue and groove joints, large male and female joints. Recommended for valves high pressure pumps. Highly suitable for use where limited gasket sealing width is available
Spiral With Only Outer Ring Used As Centering Device And Compression Stop – This is a standard Spiral Wound Gasket consisting of a sealing element and a solid metal outer ring. The outer ring performs the following important functions. (A) Centers the gasket in the joints (B) Furnishes extra radial strength to help prevent gasket blow out (C) Resist Atmospheric conditions (D) Provides a gauge reference point for detemining compression during bolt pull up. This kind of gasket are used in (1) Raised Face And Raise d face Slip –on joints (2) Plain or Flat Face Joints (3) Van Stone Joints (4) Lapped Joints (5) Welding neck Flanged joints
Spiral With Only Inner Ring used as a high pressure temperature capability - for groove flanges and general applications. This type of gaskets are used in Pressure vessels , Pumps, Boilers, Manholes, Caps, Covers etc.
Spiral With Inner And Outer Ring Of Solid Metal For High Pressure And Temperature Applications.. This are suitable for use with flat and raised face and recommended for high pressure temperature service, particularly where corrosive or toxic fluid are involved. Highly suitable for vaccum services.
Spiral With Inner Or Outer Or With Partition Ribs acts as a pass bars. Manufactured to customer design. Construction of this gasket will have sealing element with the metal clad asbestos, solid metal pass ribs for use in Heat Exchanger and Pressure Vessels. These type of gaskets are always designed to suit customer’s requirement.

Annexure

Filler Material
Recommended Maximum Temperature
Graphite
550°c
PTFE
260°c
Non Asbestos/CAF
350°c
Ceramic
650°c


METALLIC GASKETS

Heat Exchanger Metal Jacket
Corrugated Rings
Solid Metal Gaskets
Camprofile Gaskets

API Ring Joints




Soft Iron Oval or Octagonal
Stainless Steel 316 304 321
F5
Low Carbon Steel

Copper Washers

Manufactured in solid or clad form. Clad Non Asbestos form allows minimal compression as they are softer than solid. They can be manufactured in all shapes:

Round
Square
Obround
Oval